Watch Tool Kit-Everything to Open & Change Watch Batteries TK102W

Product Description

• Jaxa Type Case Opener.
• Pin Pusher With Wood Handle.
• Wood Handle Back Opener Knife, 5.25" length.
• 3 Screwdrivers With Swivel Heads. Helps remove clasps screw holding the battery in the watch.
• Red Plastic Tweezer, non-conductive, for handling batteries 4.75"
• Brass Tweezer 4.75": Plastic and brass tweezers are antistatic to avoid short circuit for battery handling.
• 3 SA Anti Acid Anti Magnetic Stainless Steel Tweezer 4.5"
• 5 SA Anti Acid Anti Magnetic Stainless Steel Tweezer 4.5"
• Plier 4 7/8" Plier With Cushion Grips & Spring Opening Flat Nose. Useful for pressing, bending clips and clasps.
• Buff Stick, 9" length x .75" wide: this is to clean a steel watch case or a gold object to give luster after normal wear and tear.
• Ball Pein Hammer 1 ounce. Length 7.25". Ball Pein and flat heads. Used with the pin punch to remove stubborn pins.
• Siliconised Cloth 12" x 12" for polishing diamonds and watches and jewelery. Like new when washed. Used to clean the watch after the battery replacement.
• Assorted Package of 100 steel spring bars: Spring Bars should be replaced when doing your watch "tune up".
• 2 Piece steel Pin Punch Set. 80 mm & 1.00 mm: This tool is used to remove stubborn links from buckles or steel belts.
• Pin Pusher with wooden handle, used same as above but with the comfort of wood.
• Pintong 4 Mouth: to hold very tiny pins where the need is to shorten or polish the item.
• Watch Hands Presser: has two holes useful for pressing the hands in place without damage.
• Watch Hands Remover Presto: to remove dial the hands have to be extracted from the face of the dial. Hands remover is put on the face of the dial and side pressed to remove the hands.
• Fibre Glass Scratch Brush: the bristles are fibre glass and help remove carbon deposit on contact points where battery is placed. Helps insure good contact in positive & negative contact points.
• Spring Bar Removing Tool, Black. This has a pointed end and a U type pin which facilitates removing of Spring Bar from watch case.
• Jewelers Loop Magnifer: this is useful to check small parts and also magnify tiny screws.
• Waterproofing Silicone Grease: every watch opened needs to be applied with silicon grease before back is pressed into place to insure waterproofing of the watch.
• Bracelet Holder, plastic: to hold bracelet/straps and use with pin pusher to remove the bracelet pin.
• Casing Cushion: to be used for opening the back of the watch (face down) to ensure that the glass or dial is not scratched.